Manitou MLT630-115V CP ELITE ST5
Show more photos
Info about the machine
- Specifications
- More specifications
- Downloads
Lifting height (mm)
6,000
Lifting capacity (kg)
3,000
Transmission
Hydrostatic 38 km/h
Power source
Diesel
Weight (kg)
6,640
Construction height (mm)
2,140
Length (mm)
4,780
Width (mm)
2,060
Manitou MLT630 supports lifting and material handling on site
Manitou MLT630 is a telehandler built for lifting, loading and internal transport across demanding work areas. It has a lifting capacity of 3000 kg and a lifting height of 6000 mm. These figures make it relevant for daily handling of palletised goods, feed, materials and general site loads. The duplex boom supports controlled placement where height and forward reach are both needed.
The machine weighs 6640 kg. It is 4780 mm long, 2060 mm wide and 2140 mm high. These dimensions provide a clear basis for assessing access conditions, storage areas and movement between buildings or work zones. For buyers comparing machine size against lifting performance, this balance is an important part of the evaluation.
The chassis layout supports controlled handling in confined working areas
Four wheel steering gives the telehandler good manoeuvrability when space is limited. This is relevant in yards, barns, loading areas and mixed work sites where turning space is restricted. Precise steering supports repeated handling tasks and helps the operator position the machine accurately during loading and placement.
The tilting fork carriage supports fork work where load angle matters during handling. The machine is fitted with 125 x 45 x 1200 mm forks in FEM 3A format. This setup is relevant for pallet handling, loading and movement of materials that require stable support across the fork length. Attachment hydraulic locking also helps when changing tools during a working day.
The boom and attachment setup support repeated loading cycles
The duplex boom is paired with Active CRC boom suspension. This configuration is relevant when the machine travels with a load across uneven ground. It helps limit movement from the boom during transport and supports steadier handling between pick up and drop off points.
For companies using several attachments, hydraulic locking adds practical value in daily operation. It reduces manual steps during tool changes and supports a faster shift between tasks. This is useful where the telehandler works with forks and other front mounted equipment during the same shift.
The cab is equipped for long working days across changing conditions
The cab includes heating and automatic air conditioning. An electric side window in the door supports ventilation and communication during loading work. The machine also has an electric mirror with de icing, which is relevant in cold and wet weather.
The seat is a low frequency air suspension cloth covered GRAMMER seat. Bluetooth USB car radio with extra microphone is also included. These features matter for operators spending many hours in the machine and for sites where communication and routine vehicle use are part of daily work.
The engine and visibility package support daily use and site awareness
The engine aftertreatment system includes DOC, DPF and SCR with AdBlue. A reversible fan is also fitted. These components are part of the machine configuration and are relevant for companies assessing service planning and operating conditions.
SafeView camera pack is included with one rear camera and one right hand side camera. This improves visibility around the telehandler during reversing and close range handling. For sites with regular traffic, structures or stored materials, that visibility support provides useful information for safer machine movement.